|
Section
fingers are precision machined from rolled steel bar stock for maximun strength.
Minimum reverse bend for all models
is 1/2", OR 1/4" minimum reverse bend may be
ordered on all models.
Beam adjustment.
(Maximum clamp setback) for all models is 1" Additional setback my be ordered.
Heavy Struts Rods
under table, on & behind clamp, and under aprons are adjustable so you
can maintain true centers.
S & L models have
openings at clamp ends allowing you to form 3 sides of a pan to depth shown
under "Max Depth of Box" in the table below.
BP & U model Finger Widths,
depending on the model, one or two 2", two or three 3", and the
rest 4". Or you may specify the widths and mix. A spare 4" finger is included
with all U models, and is optional on BP models. Use it to cut a slot at an
odd width, like 3/4" or 1-3/8". Additional spares and complete sets
are so inexpensive you may want several for experimenting.
SPECIAL 4" CUT BACK FINGER to
bend up to 4" of 3/16" mild steel w/o adjusting
set back or clamp pressure (or damaging one of the "good"
fingers), is included with all U model, and is optional for 16ga BP models.
Many special applications require radius
on the nose or on the fingers. You can get them here.
Many BP and U models are available with long fingers allowing box depths up
to 6".
IMPORTANT feature:
Each finger is individually adjustable for leading edge alignment, greatly
increasing useful life of the set.
Center leg, included with all 8 & 10 ft models and some 4 to 6 ft models,
may be installed for easier hemming while minimizing need to preload struts.
The result is easier hemming and less wear on you and your brake.
|